ConnectGear WP440G Manual de usuario

880022..1111gg WWiirreelleessss LLAANN PPCCII CCaarrdd User Manual Version: 1.0 (April, 2004)

F. Click “Finish” to complete the installation. G. The “RaConfig” is displayed and you can start to configure the card. 5

3 Configuration Utility The Configuration Utility is a powerful application that helps you configure the PCI card and monitor the link status and th

Parameter Description Available Networks This list shows all available wireless networks within range of your card. It also displays the informatio

3.2.1 Configure the Profile System Configuration Parameter Description Profile Name Define a recognizable profile name for you to identify the d

Parameter Description Network Type Infrastructure – This operation mode requires the presence of an 802.11 Access Point. All communication is done

Authentication vs. Security Parameter Description Authentication Type This setting has to be consistent with the wireless networks that the card

Parameter Description Encryption Mode None – Disable the WEP Data Encryption. WEP – Enable the WEP Data Encryption. When the item is selected, you

3.2.2 Enable WPA in Windows XP Wi-Fi Protected Access (WPA) is a specification of standards-based, interoperable security enhancement that strongly

3. Press “Configure” button to configure the WPA function for the current network. Note: Uncheck “Use Windows to Configure my wireless netwo

Parameter Description Data Encryption WEP – In WPA or WPA-PSK mode, WEP is also able to be the encryption method for the transmission data. TKIP –

COPYRIGHT Copyright 2004/2005 by this company. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed,

Parameter Description Current Tx Rate Display the transmission rate of the network. The maximum transmission rate is 54Mbps. Throughput (Kbits/se

3.5 Advance This option enables you to configure more advanced settings, for example: wireless mode, protection mode and etc. Parameter Descripti

Parameter Description ADHOC_OFDM When the network type is in Ad Hoc mode, that the card can only work in 11b data rate. It is defined by Wi-Fi orga

4 Troubleshooting This chapter provides solutions to problems usually encountered during the installation and operation of the card. 1. What is

6. What is BSS ID？ A specific Ad hoc LAN is called a Basic Service Set (BSS). Computers in a BSS must be configured with the same BSS ID. 7. What

13. What is Spread Spectrum？ Spread Spectrum technology is a wideband radio frequency technique developed by the military for use in reliable, secur

Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital dev

R&TTE Compliance Statement This equipment complies with all the requirements of DIRECTIVE 1999/5/EC OF THE EUROPEAN PARLIAMENT AND THE COUNCIL o

CONTENTS 1 INTRODUCTION...1 1.1 Features...

1 Introduction Thank you for purchasing the 802.11g Wireless LAN PCI Card. This card complies with IEEE 802.11g standard, which supports up to 54Mbp

• Security: 64/128-bit WEP Data Encryption, WPA, AES and IEEE 802.1x • Antenna: External detachable dipole antenna (Connector: RP-SMA connector, Cab

2 Installation Procedure Before you proceed with the installation, please notice following descriptions. Note1: The following installation was opera

C. Click “Easy Install” or “Next” to continue. D. The system starts to install the software of the card. Please wait a moment. E. The curr